What is placed in critical pressure points of the distribution network to establish DDD?
How can a water tower be retained without affecting the required network pressure?
What is a result of pressure zoning?
What is the general purpose of a water tower?
What is unique about the algorithm used to manage pressure with DDD?
What happens with the control valve if network pressure gets too low?
How is a DMA created?
What does DMAs make it easier to localise?
Teszt eredmény
Q: What is placed in critical pressure points of the distribution network to establish DDD?
A: A booster set
Q: What is placed in critical pressure points of the distribution network to establish DDD?
A: Pressure-reducing valves
Q: What is placed in critical pressure points of the distribution network to establish DDD?
A: Sensor data-loggers
Q: How can a water tower be retained without affecting the required network pressure?
A: Using a hydraulically operated control valve to fill and empty the water tower
Q: How can a water tower be retained without affecting the required network pressure?
A: By filling the water tower at night time when consumers are asleep
Q: How can a water tower be retained without affecting the required network pressure?
A: Using a small booster pump to supply water to the tank and a two-way hydraulically-operated control valve to remove water from the tank
Q: What is a result of pressure zoning?
A: The booster pump and most of the network will operate at a higher pressure
Q: What is a result of pressure zoning?
A: The main station and most of the network will operate at a much lower pressure
Q: What is a result of pressure zoning?
A: The main station and most of the network will operate at a higher pressure
Q: What is the general purpose of a water tower?
A: To keep the water in the distribution pipe network pressurised
Q: What is the general purpose of a water tower?
A: To boost pressure in the distribution area
Q: What is the general purpose of a water tower?
A: To keep a volume of water for emergency use
Q: What is unique about the algorithm used to manage pressure with DDD?
A: It is self-learning
Q: What is unique about the algorithm used to manage pressure with DDD?
A: It determines the pressure setpoint
Q: What is unique about the algorithm used to manage pressure with DDD?
A: It is in the cloud
Q: What happens with the control valve if network pressure gets too low?
A: The control valve will open to maintain the minimum network pressure
Q: What happens with the control valve if network pressure gets too low?
A: The control valve will close, stopping water from entering the network
Q: What happens with the control valve if network pressure gets too low?
A: The control valve does not respond to network pressure
Q: How is a DMA created?
A: By closing valves within the distribution pipe network to create a zone and installing flowmeters where valves are left open to register the volume of water supplied and removed from the DMA
Q: How is a DMA created?
A: By leaving open a few valves within the distribution pipe network and installing consumer meters to register water supplied to the DMA
Q: How is a DMA created?
A: By closing valves within the distribution pipe network and installing flowmeters to register water supplied to the DMA
Q: What does DMAs make it easier to localise?
A: High Pressure
Q: What does DMAs make it easier to localise?
A: Leaks
Q: What does DMAs make it easier to localise?
A: Customer complaints