3 questions Basic

ECADEMY test

78 - Sizing your pumps in GPC

This course test contains 3 questions and can be retaken at any time.

You must answer all questions correctly to pass the test and complete the course.

Start test

Question 1 of 3 Basic

Which two data values do you need to enter before sizing your product by application?

Question 2 of 3 Basic

Which of these factors are energy consumption calculations not based on?

Question 3 of 3 Basic

Happy with your answers?

Submit your current answers and get the final test result.

Submit

Test results

Congratulations. You have passed the test and completed the 78 - Sizing your pumps in GPC

Achieved badges:

How would you rate this course?

You are welcome to add your rating of this course. Remember that you have to be logged in before you take the test to be able to give your rating.

Continue training Go to MyECADEMY

Sorry. You did not pass the 78 - Sizing your pumps in GPC test this time

How would you rate this course?

You are welcome to add your rating of this course. Remember that you have to be logged in before you take the test to be able to give your rating.

Correct
Q: Which two data values do you need to enter before sizing your product by application?
A: Head and flow
Correct
Q: Which of these factors are energy consumption calculations not based on?
A: Pressure
Correct
Q: How are the products listed when you perform a quick pump sizing?
A: In descending order according to best life cycle cost