Where do vortices develop if the propeller is too close to the water surface?
What is the main purpose of a closed loop tank?
What is the aim of thrust-to-power sizing?
Which of these describe the specific mixing power?
How did the Stargard project redesign the layout of mixers in the tank?
Test results
Congratulations. You have passed the test and completed the 20 - Mixing in Wastewater Treatment
Achieved badges:
Q: Where do vortices develop if the propeller is too close to the water surface?
A: At the front of the propeller
Q: Where do vortices develop if the propeller is too close to the water surface?
A: At the rear of the propeller
Q: Where do vortices develop if the propeller is too close to the water surface?
A: Underneath the propeller
Q: What is the main purpose of a closed loop tank?
A: To create a steady, circulated flow
Q: What is the main purpose of a closed loop tank?
A: To ensure a more energy-efficient solution
Q: What is the main purpose of a closed loop tank?
A: To prevent damaging backflow
Q: How much was the average velocity of the volume improved by?
A: 20%
Q: How much was the average velocity of the volume improved by?
A: 25%
Q: How much was the average velocity of the volume improved by?
A: 30%
Q: What is the aim of thrust-to-power sizing?
A: Maintain a steady momentum and a constant required thrust rate
Q: What is the aim of thrust-to-power sizing?
A: Deliver a sufficient thrust with the least possible energy consumption
Q: What is the aim of thrust-to-power sizing?
A: Run the power at the limit to deliver maximum thrust when necessary
Q: Which of these describe the specific mixing power?
A: The ratio between the propeller power and the liquid volume
Q: Which of these describe the specific mixing power?
A: The ratio between the liquid volume and the solid particles
Q: Which of these describe the specific mixing power?
A: The ratio between the propeller power and propeller size
Q: How did the Stargard project redesign the layout of mixers in the tank?
A: They gathered four mixers in the middle of the tank
Q: How did the Stargard project redesign the layout of mixers in the tank?
A: They spread four mixers across the tank
Q: How did the Stargard project redesign the layout of mixers in the tank?
A: They remained in the same position, but were replaced with more powerful mixers