4 questions Intermediate

ECADEMY test

38 - Additional Circulator Knowledge

This course test contains 4 questions and can be retaken at any time.

You must answer all questions correctly to pass the test and complete the course.

Start test

Question 1 of 4 Intermediate

Do you always have to remove the whole pump in a replacement job?
Yes, the whole pump must be removed
No, in some cases you only need to replace the pump head
Previous Next

Question 2 of 4 Intermediate

Is it necessary to close the existing pump’s two shut-off valves before replacing it with an ALPHA2?
No
Yes
Previous Next

Question 3 of 4 Intermediate

Which is the default control mode in an ALPHA2?
Constant pressure mode
Proportional pressure mode
AUTOADAPT
Previous Next

Question 4 of 4 Intermediate

Does the assembly of the ALPHA plug require any tools?
No, the plug is assembled by clicking it into place
Yes, a small screw driver is needed
Previous Next

Question 4 of 4 Intermediate

Happy with your answers?

Submit your current answers and get the final test result.

Submit
Go back to review answers

Test results

Congratulations. You have passed the test and completed the 38 - Additional Circulator Knowledge

Achieved badges:

Continue training Go to MyECADEMY

Sorry. You did not pass the 38 - Additional Circulator Knowledge test this time

Retake test Continue training
Correct
Q: Do you always have to remove the whole pump in a replacement job?
A: No, in some cases you only need to replace the pump head
Correct
Q: Is it necessary to close the existing pump’s two shut-off valves before replacing it with an ALPHA2?
A: Yes
Correct
Q: Which is the default control mode in an ALPHA2?
A: AUTOADAPT
Correct
Q: Does the assembly of the ALPHA plug require any tools?
A: No, the plug is assembled by clicking it into place
Continue training Go to MyECADEMY
Retake test Continue training