8 questions Basic

ECADEMY test

Basic hydraulics and pump performance

This course test contains 8 questions and can be retaken at any time.

You must answer all questions correctly to pass the test and complete the course.

Start test

Question 1 of 8 Basic

1 Identify the correct formula for calculating pump efficiency.

Question 2 of 8 Basic

2 Identify the reasons for reduction in pump performance from the given options:

Question 3 of 8 Basic

3 Select the three parameters of most interest in water pumping systems:

Question 4 of 8 Basic

4 What are the effects of cavitation on pumps?

Question 5 of 8 Basic

5 Which of the following parameters is not used for calculating pump efficiency?

Question 7 of 8 Basic

7 Which of the following items are built-in in some motors and can stop the motor if it exceeds a preset temperature:

Question 8 of 8 Basic

Happy with your answers?

Submit your current answers and get the final test result.

Submit

Test results

Congratulations. You have passed the test and completed the Basic hydraulics and pump performance

Achieved badges:

Continue training Go to MyECADEMY

Sorry. You did not pass the Basic hydraulics and pump performance test this time

Correct
01.
Q: Identify the correct formula for calculating pump efficiency.
A: HxQ/cxP1
Correct
02.
Q: Identify the reasons for reduction in pump performance from the given options:
A: Bad power supply
Correct
03.
Q: Select the three parameters of most interest in water pumping systems:
A: Flow, head and energy
Correct
04.
Q: What are the effects of cavitation on pumps?
A: Pitting of impeller and pump housing
Correct
05.
Q: Which of the following parameters is not used for calculating pump efficiency?
A: Time
Correct
06.
Q: Which of the following is one correct method to avoid cavitation?
A: Reduce the friction loss in the suction pipe.
Correct
07.
Q: Which of the following items are built-in in some motors and can stop the motor if it exceeds a preset temperature:
A: Temperature sensors
Correct
08.
Q: How can friction loss in a system be minimised?
A: By increasing the pipe diameter