Question 1 of 6
Intermediate

What happens if the water level in the well drops below the inlet?

Question 2 of 6
Intermediate

Which of these isn’t a key dry-run protection benefit for the installer?

Question 3 of 6
Intermediate

The 3” SQ pump is obviously ideal for new boreholes but where can it also be used?

Question 4 of 6
Intermediate

In addition to limiting the current draw from the mains during start-up of the pump, how does the soft-start functionality benefit operation?

Question 5 of 6
Intermediate

How does the integrated dry-running protection work?

Question 6 of 6
Intermediate

By how much does the supply voltage decrease before the motor contactor stops the pump?

Question 6 of 6
Intermediate

Happy with your answers?

Submit your current answers and get the final test result.

Test results

Congratulations. You have passed the test and completed the 37 - Grundfos SQ/SQE
Sorry. You did not pass the 37 - Grundfos SQ/SQE test this time
Achieved badges:
How would you rate this course?
1: What happens if the water level in the well drops below the inlet?
The motor power consumption drops
1: What happens if the water level in the well drops below the inlet?
The motor power consumption stays the same
You can find the answer here >
1: What happens if the water level in the well drops below the inlet?
The motor power consumption increases
You can find the answer here >
2: Which of these isn’t a key dry-run protection benefit for the installer?
The installer can avoid costly callbacks
You can find the answer here >
2: Which of these isn’t a key dry-run protection benefit for the installer?
The installer doesn’t have to worry about additional components
You can find the answer here >
2: Which of these isn’t a key dry-run protection benefit for the installer?
The installer doesn’t have to worry about water bursts
3: The 3” SQ pump is obviously ideal for new boreholes but where can it also be used?
In wells with water temperature up to 60° C.
You can find the answer here >
3: The 3” SQ pump is obviously ideal for new boreholes but where can it also be used?
In installations that require constant pressure.
You can find the answer here >
3: The 3” SQ pump is obviously ideal for new boreholes but where can it also be used?
In original 4” boreholes where sediments over the years have narrowed the hole.
4: In addition to limiting the current draw from the mains during start-up of the pump, how does the soft-start functionality benefit operation?
Soft start reduces over-pressure in your piping.
You can find the answer here >
4: In addition to limiting the current draw from the mains during start-up of the pump, how does the soft-start functionality benefit operation?
It reduces the occurrence of water hammer in the pipes and minimises wear during start-up.
4: In addition to limiting the current draw from the mains during start-up of the pump, how does the soft-start functionality benefit operation?
Soft start prevents the motor from getting warm.
You can find the answer here >
5: How does the integrated dry-running protection work?
It automatically restarts 3 minutes after shut down.
You can find the answer here >
5: How does the integrated dry-running protection work?
It prevents sand from damaging the pump.
You can find the answer here >
5: How does the integrated dry-running protection work?
It automatically shuts down the pump if water shortage is detected.
6: By how much does the supply voltage decrease before the motor contactor stops the pump?
More than 10 %
6: By how much does the supply voltage decrease before the motor contactor stops the pump?
More than 15 %
You can find the answer here >
6: By how much does the supply voltage decrease before the motor contactor stops the pump?
More than 20 %
You can find the answer here >